Reproducible Vision-Guided 6-DoF Robotic Manipulator with a Mixed Stepper-Driver Architecture and Browser-Native Control

Engineering notes

Engineering notes will be added by the Robot Papers editorial team.

Chinese explanation / 中文解读

中文解读待补充：本站会优先为 VLA、具身智能、人形机器人控制、机器人操作等高价值论文补充中文说明。

Original abstract

We present the NeuralNexus Arm, an open, low-cost 6-DOF robotic manipulator built by an undergraduate engineering team, together with the design decisions and debugging experience needed to reproduce it. The arm is driven by a single STM32H743 microcontroller on a custom printed circuit board (PCB) and combines two stepper-driver strategies on one controller: push-pull 3.3 V step/direction outputs for onboard TMC2209 drivers on the three wrist joints, and open-drain outputs for external CL57T and DM542 drivers on the three high-torque proximal joints. We describe the mechanical design, mixed-driver electronics, interrupt-driven firmware, a MATLAB/Simscape-based inverse-kinematics pipeline, a browser-native control interface using the Web Serial API, and a lightweight vision pipeline for object localisation and autonomous pick-and-place tasks. We also document non-obvious hardware and firmware failure modes encountered during the transition from a development board to the custom PCB as reproducibility guidance. All design files and firmware are released openly. The platform actuates all six axes under coordinated control at a 2 kHz update rate and executes both manual and pre-recorded motions from the browser interface.

Links and sources

• Official / arXiv page
• PDF from original source

Comments